KUHN AXIS Mineral fertilizer spreader™

The accuracy of the input has not been changed!

Get familiar with the overhead distribution boxes by adding AXIS EMC with a working width of 12 to 50 m and a bunker volume of 1000 to 4200 l.

KUHN's unique solution ensures absolute spreading accuracy: EMC (Electronic Mass Flow Curing) automatically and independently regulates the application rate from the left and right side at the right time of spreading. In addition, the CDA system was rozpodіlu є voucher for the exact entry for any minds. The line of distribution of AXIS, sums of ISOBUS - the best solution for the introduction of good.

Calling system W: "continuous adjustment"

Models AXIS 20.2 W, AXIS 30.2 W and AXIS 40.2 W with a working width of 12 to 42 m equipped with a classic sounding system
Two sounding chambers, arriving at the electronic terminal QUANTRON A, allow you to automatically adjust the rate of application and the hour of spreading. In a second, the terminal controls the speed of the flow, rechecking, chi in the programming of the speed, and then vikonu regulation. This is what ensures superior accuracy and comfort of the koristuvach.
The design of the original patented sounding system is made up of a mechanical hinged frame, possessed by two sensors of the foot with the possibility of 10 tons of winding on the skin, and the rear traction, attached to the frame of the machine. Two zvazhuvalnі komіrki guaranty high accuracy navit when working on the scales. The height of the lock can be two positions, so that we can work with the help of the entry. The fixed frame has a significant gap for switching gears.
Just set the application rate, work the width of the drop point (deposit in the machine), and the system constantly controls the time of the spread, automatically corrects the position of the shutters, as if an inaccuracy is detected.

The CDA wild rose system is unfinished!

The unique CDA system (Coaxial Adjustment of the Diffusion) ensures the optimum bead distribution. Changing the point of impact by adjusting allows you to quickly adapt to different trims and different working widths. The special design of the dosing shutters allows you to regulate the flow of fertilizer to the blades and, therefore, to ensure the constant flow of fertilizer and equal distribution. The CDA system ensures the accuracy and accuracy of the distribution. Change the rate of entry and the speed of the machine, do not add to the rozpodіl dobriv. The stirrer, which collapses superficially properly, regulates the speed of the feed of the spreading disk and the flow of the feed is good. Wrapped around with a total of 17 revolutions / min, the mixer saves the integrity of the granules. In order to guarantee the accuracy, the shoveling was applied to the disk, streaked straight down until the moment when the shoulder blades splutter. When AIRFIN blows, it changes the turbulence that occurs when wrapping the disc, which ensures a regular flow of good.

VARISPREAD PRO: Sectional cutting on high arches behind the assisted SpeedServo system

The new SpeedServo carving system is made up of 4 electric motors, 2.5–5 times used for traditional ones. It changes the falling points and adapts it to the robot of the rozpodilny disk to form the field. Polіpsheno keruvannya by crossings: the correct rate of application is zastosovuєtsya at the required places, wind on high swidkos.
VARISPREAD PRO is available on models AXIS 40.2 and 50.2 with mechanical or hydraulic drive.